"my shower" I is actually easy done.

The main work was the pump out and the way to understand what kind of pump works.

If u use a manual Bilge pump and a new bucket itll work also.

If it's cold and windy and girl and other people near, outside shower is not the best...

My shower setup

viewtopic.php?t=28654

Best thing ever.!

I often raise the Mast when docked in the water.

Does not matter. When you already have the Mast raised it is easier to dock an walk along the boat. That's all.

About Katadyn water maker... Und show your install please when ready to go!

It modulates to its lowest rate of fire, but stays on. this is normal, my china heater does the same. there are heater that turn completely off and start again depending on temperature. I have the 2kw heater so the heat is not so high anyway. Maybe the 12V-consumption could be higher becouse the 10...

The only reason for the platform for me was easy docking in the Mediterranean. There you drop the anker, then move back to the dock. With the macs the problem is you cannot get out of the boat backwards because of the OB, the boat is to far away from the dock. With the platform you could do this eas...

I like it. Especially when single handing and mooring.


Not clear fir me: how you can reach the ladder in an emergency, when up in sailing position?

To be honest... to answer the thread question, if you fall ober bord mostly you will die. With life west somewhat later. Ray-line may help to get contact to the boat. Or a line you pull back of the Mac. May give you a small chance. But imagine how fast the boat rides... Und and how slow you are... Y...

What is the diameter of the drum?

just to ask: How many capsized you know about with ballast tank full???

Tethers could help if you deal with sails. Or if you fall over your own feet...

Ok, so the ones marked “new” are the upgraded ones from BW? I’ve had my boat 14 years and am still on the original set. They are bent at the bottom. I do quite a bit of sailing. I finally put a compression stud inside the rudder pivot, which is now a half inch. This system reduced the slop, and mak...

If memory serves, the aluminum brackets that cracked and bent were simply held in place by a vertical axle. We didn't have to remove the plate that goes against the fiberglass wall. That was still in good condition. It could be done easily in waist-deep water. Not hard at all. (It was definitely ea...

Yes, my 2011 had the small ones.
with the heavier it is much better!

Cool...
let's see the result!

I am working to install a vevor 2kw. But it shall sit outside at the back of the

Waiting for some last items...
will post pics if it will work...

I hope to make the season longer this way...