I should be getting her back today from getting new decals. I'll try to get some pics.
KB

Hi guys, I have a teak shelf that was mounted by screwing it directly into the liner on the port side near the companionway. The road vibration has caused it to fall off a couple times. I tried double sided tape and larger screws, Nope. I tried epoxying stainless threaded washers. Nope they popped o...

I literally just read this. Crazy. Everything is getting cut right now. I have been subject to both equipment and power failures as well as well as solar flare error.

I just got mine! She will be flying it proudly.
KB

Overeasy,
I would try the lube that I mentioned before drilling. No need to drill. A couple of strokes after you lube and you can move it with one finger. Lube the rubber groove and the stem. All done. The stuff is cheap too. I'm done with lithium grease.
KB

Be careful,

Regular grease will eat the rubber seal.
KB

I'm in. Just ordered mine.

Foe all of you with the ballast slide valve on your boat, I have found the best lube. I have tried white lithium with poor results. The stuff turns chalky in no time and the valve gets harder to move than before. I got this stuff from Amazon for plumbing valves and O-rings for the house and gave it ...

Very cool. I mounted a tube on the port side for my stern anchor. I'm thinking of putting the dinghy motor on the starboard like you. Lower if possible. I have my VHF antenna on the starboard side by the seat as well. Busy area. Thanks for the feedback.

Nice spot!! I am hoping to utilize the stern seat rail. Mounting a bracket on the M would be a bitch and would get in the way of the rudders when up. Thanks for the pic.
KB

Well, 6 months post spine surgery, 2nd one, and I am ready to go for this season. After being sidelined for a year from sailing I am ready to get Moondancer ready to go.(2005 26M. Honda 50). We just need some good weather. Melting ice and snow right now but I am sure there is more to come. Over the ...

I went from a 1977 V25 to an M. It was from a club member and a deal I couldn't refuse. I thought I would have trouble selling my 25 but I got all the money. I invested in new steering from BWY and installed a lot of upgrades given to me with the boat. I does not sail like the V at all. I do miss th...

I agree with checking the connection. That's usually where the problem is. I went through a bunch of the deck connectors. Junk. The dinghy would wipe them out when on deck and the always were a PIA. I left the deck section in place and ran a trailer connector through the the existing deck connection...

I bought a 1977 V25 17 years ago and it was the best thing I ever, ever bought. Raised my kids as sailors. Night sails to Martha's Vineyard while they were sleeping with life jackets on and many, many adventures. And misadventures!! Everyone was impressed by how fast it was. A couple of years ago a ...

Had to be no ballast. The heeling was a dead give away. There was no wind. With no ballast to right the boat it would lay down on its side, Past 90 degrees fill and rest on the shallow bottom. No pump would fix that. Operator error. Maybe he left the keel down too. If she were on her side it may not...