Well a shutoff switch is not on this boat. The throttle is a honda control with the non start in gear control on the motor itself. The ignition switch is on the pedestal.below the steering wheel. So I need to tie in the ESO wires at the ignition switch wiring harness. Just not sure which wire to tie...

I want to add an emergency motor shut off switch to my 2008 26M. It has a Honda 40hp the PO had repowered with. Does anyone have a Honda 40 or 50 with a shut off switch installed and can show/tell me where their switch is installed and how it is wired in? I don't think it is absolutely required but ...

Thanks for the info. I suspected there were calculations and was not sure extra length would help or hurt. Better to ask before cutting. Would not be able to recut longer later. :| Spreaders are cut and installed. Ordered new tips due to corrosion between stainless screws and aluminum tips. Should b...

One of my aluminum spreaders broke at the holder on my 26m. I drilled a new hole and reinstalled but that left the starboard side bar 1 inch shorter than the port side. I ordered some 316 stainless steel for replacements. But could only get 48 inch lengths. This is approximately 4 inches longer than...

Thanks for the informatio. The zocar site has sparked wantagetit now how to justify it with financial advisor!

Does anyone know what a cockpit door for a 26X cost?

Jimmt,
Iplan on sailing mostly. So probably try to how low I can get to miss the boom and how much head room that would leave. I usually saol with long sleeves and a uv protection hat so sailing with bimini down is fine. Hope the weather warms up.next week!

Jimmyt, The frame has the fiitings for the middle bow to fit in. The cover has the sleeve. It is good to know what the original should look like. Guess I have an after market cover and frame. It is larger than I expected. Now I need figure out who made it. Easy Peezy ! It mybe taller also. With the ...

Not a lot of sailig. Started with catalina 22 in 2014. Sailed it went to a couple of races. Sold it and got 26X got took on that deal didnot know what to look for. The boat had been rewired with alarm wire. It did have Billy box ac, tv , shore power, battery charger and converter DC to AC, custom bu...

Hey Jimmy I sail out of dog river also. Boat is stored at Alba Club. Just recently purchased 2008 26m. Had sails up first time 10/22/22.

Ok now I understand. When I get back to Knot T1 I try getting some shots. Thanks.

Pitcnpolehobie
The replacement tubes, did the seller make one or happen to be selling the size you needed?

Gotta fix the profile. Had an X but had too many issues. Sold it and did not plan on another boat.Then I came across this M so back on the water again. In Mobile, Al. Previous owner doesn't know if the Bimini is original or not. When I found the middle bow missing I was hoping to find an inexpensive...

I put stainless steel mesh sink strainers upside down and mounted with 2 small stainless screws over the drain inlets. Large one for motor well and small one for anchor. This keeps debris out of the drains and helps with free flowing. Just wipe debris out as it buils up around the strainer. Not much...

Opened up bimini for the first time. The middle bow is missing. I don't know if this is the original bimini or not. Anyone know how to identify it. Looks like 3/4" stainless frame 3 bow. Fits the the jib slide holders. Aporox. 70" wide frame at the base.Has a sleeve the mid bow should fit ...