I removed my 26X helm seat 20 years ago and have had no issues.
Rob

Wow. My forward hatch gasket is installed on the hatch and not in the groove for the hatch. The gasket lands on the interior lip. It has been that way since I purchased in in 2003. It should make align easy.

Rob
95 26X 60 Mercury

Anybody make a replacement gasket for their stove? I was thinking of cutting a circle from an inner tube.
My 96 26X stove gasket was damaged about 10 years ago.

Rob

I used a hand impact. Big screw driver bit on one end and you wack the other end with a hammer.
Similar to this:
https://www.harborfreight.com/impact-sc ... 37530.html

Thanks. I was not looking at the "Gear Housing Driveshaft". I found the complete kit part number.

That is the Mercury site I went to and when I put in my s/n the only water pump parts listed is for a jet. Must be the same
parts.

2015 Mercury 60 ELPT: (s/n1C220792) Where do you purchase your water pump impeller kit from in the USA? Tried Mecury's site for the part numbers but could only find parts list for a jet drive not prop.(?)

I was thinking of using Gorilla glue. I can attest to its holding power. I had to glue the heel back onto my dress shoes a few years ago when I was out of town on business. Purchase it from home depot and went back to the hotel. I lathered it onto the the rubber heel and used a hotel chair to hold i...

Yup, that is what mine does. I usually shove it back into the slot and close the door too.

Has anyone glued the edging on the head door back on for a 26X? Which glue did you use?

Rob H

Yeah!!!

Do you use Mercury's or Quicksilver Oil or do use an oil available for use in cars?

Changing the oil in my 60 HP 4 stroke Mercury. What do you use?

I have a 95 26X with the original rope foot mainsail which I intend to replace. Apparently Loose foot is the way to go but I am not sure how the loose foot mainsail tack attaches. My boom has a plain aluminum rod from inside the boom that connects to the mast with the inverted J bolt used for reefin...

Late 95 26X trailer: I have a ring on the axle spindle part#1 on the diagram. http://www.bearingbuddy.com/images/spindle.gif I believe this is a bearing buddy Spindo seal part. Should I remove this and go with the standard seals or purchase theirs? Once I am done rebuilding brakes/bearings I will no...