Need some advice for upcoming Mods

A forum for discussing boat or trailer repairs or modifications that you have made or are considering.
Post Reply
Bill Ernst
Posts: 3
Joined: Fri Jan 02, 2004 9:39 am
Location: Minnesota

Need some advice for upcoming Mods

Post by Bill Ernst »

We are planning a late winter trip from the frozen north and are taking our MAC to Lake Mohave and Lake Havasu. I am planning to do a few popular Mods to the boat before we go and need some advice/opinions.

Has anyone tried to install a 'bass boat' style pedestal seat in place of the factory hinged captains seat? I have looked at a few of the Mods that show the swinging seat removed but no pedestals installed.

Where can I buy a 'grab bar' for the front of the steering pedestal?

Where can I buy a replacement male plug for the mast light?

Also we have boated on Lake Mohave in the past on a houseboat so we know the lake somewhat. We have never boated on Lake Havasu so if anyone wants to weigh in on that lake we would appreciate it. :macx:

Thanks in advance for the help.
User avatar
richandlori
Admiral
Posts: 1695
Joined: Wed Aug 18, 2004 8:08 pm
Location: Living Aboard in Morro Bay, CA
Contact:

Post by richandlori »

I have never been on havasu, so can't commet there, but you can find the pedestal guard at http://www.bwyachts.com/web%20catalog%2 ... _guard.htm


Others can comment on your other questions, because I don't have a clue :)


Rich
User avatar
Duane Dunn, Allegro
Admiral
Posts: 2459
Joined: Fri Jan 02, 2004 6:41 pm
Sailboat: MacGregor 26X
Location: Bellevue, Wa '96 26x, Tohatsu 90 TLDI and Plug In Hybrid Electric drive
Contact:

Post by Duane Dunn, Allegro »

There are 2 types of pedestal guards. The one linked to above is a small loop that mounts to the face of the pedestal. I had it for awhile and it was OK, but I have since replaced it with the larger version with a table. The small loop does not go clear to the floor like those you see with the tables mounted on them. It also is not as wide as the ones that go to the floor.
Dan Cowett
Just Enlisted
Posts: 11
Joined: Sat Feb 14, 2004 11:52 am
Location: N.C.

Mast head light plug

Post by Dan Cowett »

I got my replacement mast head male plug from Havencraft.
http://www.havencraft.com/Contact.asp
Good luck.
Dan.
User avatar
Chip Hindes
Admiral
Posts: 2166
Joined: Mon Jan 05, 2004 6:13 am
Location: West Sand Lake, NY '01X, "Nextboat" 50HP Tohatsu

Post by Chip Hindes »

Powersailing also has a less expensive version of the grab bar with or without the table.

Dan, Havencraft is under new ownership, no longer carries parts and hasn't in over two years. The old Havencraft parts division is now Macgregorparts.com. This is all explained on the Havencraft website. Macgregorparts.com still has the best parts catalog on the net, but a lot of folks have bad things to say about them and they can't be recommended.

The male plug for the masthead light is available from West Marine P/N 115016.
Mark Prouty
Admiral
Posts: 1723
Joined: Mon Jan 19, 2004 8:52 am
Location: Madison, WI Former MacGregor 26X Owner

Re: Need some advice for upcoming Mods

Post by Mark Prouty »

Bill Ernst wrote: Has anyone tried to install a 'bass boat' style pedestal seat in place of the factory hinged captains seat? I have looked at a few of the Mods that show the swinging seat removed but no pedestals installed.
I thought about that and even bought the parts. I couldn't figure out a way to really make it work. I thought about how many times I sit from one side of center and felt the pedestal seat would get in the way.

I think this might be the way to go. I covered my boat for the season before I got a chance to do this mod but will be peforming it when the snow is gone:

Image

http://macgregorsailors.com/phpBB/viewt ... ght=#13362

Note: Duane says: "If I had it to do again I would make it even taller by about 2" more."
Terry Chiccino
Chief Steward
Posts: 91
Joined: Mon Jan 05, 2004 12:27 pm
Sailboat: MacGregor 26X
Location: Santa Cruz, CA., '02x,w/'09 Honda,efi

Post by Terry Chiccino »

Bill, I've got the "grab bar" that you see on the BWY web site that I'll sell you! I replaced that bar for the table/grab bar combo. It's yours for $20.00+shipping if you're interested. Terry
Post Reply