Page 1 of 1

A trailer mod

Posted: Wed May 07, 2008 4:26 pm
by TonyHouk
Hey Y'all,
So I am getting ready to move back down south to go to school there. I took the boat out and noticed that I did not have any brakes. I looked online for the master cylinders. For about $70 I was good to go. Well since most of the times it is a two person job to bleed the brakes, I waited for my Pops to get home to help me. I had some kids mess with the electro/pneumatic brake system. I thought maybe I would start with bleeding the system. Well the first few micro seconds it bled air and then the brakes were back. So the moral of the story is if you have not used the boat in a while check your brakes. If they don't work, bleed them. Have fun, Tony

Thanks for the tip

Posted: Mon May 12, 2008 10:19 am
by Wayneoh
Tony, also may want to remember to check the bearing buddies for grease while you're at it.

Posted: Mon May 12, 2008 1:47 pm
by TonyHouk
Wayneoh,
Did that but thanks for caring about me>>> Tony