MacGregorSailors.com

Posted: **Sun Jun 05, 2022 8:03 am**

Hi,

Working on refurbishing a '91 26S. The t-molding around some of the wood trim has pulled away and is extremely difficult to put back in place (and once I do so it comes back out again. How are others dealing with this issue? Is there way to get the t-molding back in place or just remove the trim and coat/epoxy the edges of the wood panels?

Thanks,

Ken

Posted: **Sun Jun 05, 2022 8:55 am**

Welcome to the forum, Ken! Glad to have you participating.

Here is a recent thread where we discussed the T molding topic some. You might want to look at that for starters.

viewtopic.php?p=352144&hilit=Edge+molding#p352144

Looking forward to seeing more of your posts and some progress pics of your boat.

Again, welcome!

Jim

Posted: **Fri Jun 24, 2022 5:31 am**

Thanks for the link, Jim. Would have replied sooner but didn't get a notification of your response (will check my forum settings and make sure reply notifications are set on).

Posted: **Sat Jun 25, 2022 6:15 pm**

I reported success earlier with using a hot glue gun on T molding... Have to withdraw that. It has not held up and came unglued in the Texas heat.

MacGregorSailors.com

Plastic T-Molding - Best way to deal with it?

Plastic T-Molding - Best way to deal with it?

Re: Plastic T-Molding - Best way to deal with it?

Re: Plastic T-Molding - Best way to deal with it?

Re: Plastic T-Molding - Best way to deal with it?