Hi all. my new-to-me boat that comes with a CDI roller furler. I notices there is a small section that is "chipped off"about 2 inch I think were the sie si broken. I hope this is not an issue. The really issue is that it is not installed right now. I have no idea how to do this, is there a guide for install - anyone have a link or something for this, before I start googleing?
Thanks all.
Kevin.
Ps- man I can't wait for the water to melt around here!
CDI roller furler install
-
AlaskaMan
- Chief Steward
- Posts: 89
- Joined: Fri Jun 26, 2009 3:44 pm
- Sailboat: MacGregor 26X
- Location: Juneau Alaska - S/V Mental Floss
Re: CDI roller furler install
http://www.sailcdi.com/ffmain.htm
Check out the website. I think you will find all the information you need.
Check out the website. I think you will find all the information you need.
-
Catigale
- Site Admin
- Posts: 10421
- Joined: Fri Jun 11, 2004 5:59 pm
- Sailboat: MacGregor 26X
- Location: Admiral .............Catigale 2002X.......Lots of Harpoon Hobie 16 Skiffs....Island 17
- Contact:
Re: CDI roller furler install
The chipped off piece may actually be the spot where you load the bolt rope into the extrusion - part of the design.... 